Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Guidelines for Inkjet Cartridge refill
02-08-2015, 06:00 PM
Post: #1
Big Grin Guidelines for Inkjet Cartridge refill
There are number of instructions to be followed at the time of refilling an inkjet cartridge. So anytime your printer ink runs dry you want to stick to the under steps for inkjet cartridge refill.

1. Its quite essential that you manage the cartridge cautiously. Avoid touching any metallic parts.

2. Usually clean needles and syringe to steer clear of any color mixing.

three. It would constantly be advisable to shop the cartridge in an airtight bag with a moist paper towel when not in use.

4. Refill the cartridge only when the warning light glows.

five. If you are re-filling black cartridge, then enlarge the fill hole on leading of the cap with the drill offered.

6. If you are re-filing color cartridge, then you have to remove the cap initial. We found out about this page is not affiliated by browsing Google Books. Either hold the cap in a secure manner or very carefully remove the cap with the support of a knife.

7. Place together needle and syringe and fill in the color that you want your cartridge to refill with.

8. Insert the needle into the correct fill hole straight down till the foam. If you are filling with the color ink then make positive you are inserting in the correct ink slot.

9. When you begin injecting the ink into the slot, make sure that you are carrying out it slowly and you may have to clean the print head with a tissue.

ten. When the color cartridge is completely complete, ink could be seen at the fill hole, slightly remove the syringe till the ink on the fill hole vanishes.

11. The capacity of the black cartridge is about 20ml, so make confident that you dont over-fill it.

12. So you have now effectively filled the cartridge.

13. Right after the method of refilling is comprehensive, re-cap the cartridge. To ensure safety, stick a tape on the top rated of the lid.

14. Clean the print head with a tissue or a sponge till the time it stops dripping.

15. Its time to install the cartridge back into the printer and run a cleaning cycle.

16. You ought to usually clean the syringe and the needle that you have utilized with water so that it can be utilised again..CarpetFirst
78 York Street
London
W1H 1DP

020 8099 8444
Find all posts by this user
Quote this message in a reply
Post Reply 


Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | The Complete Idiots | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication